Mobile Guardian 2.0 – Installation and Initial Setup
Follow these steps to install the Mobile Guardian 2.0:
![mg-2.0-installation](https://staging.medicalguardian.com/wp-content/uploads/2023/07/mg-2.0-installation.png)
- Assemble the charging cradle. Insert the large end of the USB plug into the charging wall plug. Plug the small end of the USB cord into the charging cradle.
- Plug the power adaptor into a direct wall socket that is not connected to a light switch. Avoid any power strips or power cords. A Green LED will illuminate to indicate the cradle is receiving power.
- Place the device into the charging cradle. The device will verbally state “Device Ready.” The device will turn on within a few seconds and the top and bottom LED indicators will both briefly illuminate. It normally takes 30-60 seconds for the mobile device to register with the cellular network.
- The top LED light indicator will illuminate solid green when the device is charging and will blink green when it’s fully charged.