MGMini Lite-Initial Setup & Charging
When you receive your device, take everything out of the box and charge the device.
To charge: Plug the charging cradle into an outlet. Then place your device into the cradle as shown, making sure the charging pins line up with the charging plates.
After about 5 seconds, you will hear the device say “charging.”
While the device is charging, the red battery light flashes every 5 seconds. When the device is fully charged, the battery light will be solid red.
Typical charging time is about 2-3 hours.
After about 5 seconds, you will hear the device say “charging.”
While the device is charging, the red battery light flashes every 5 seconds. When the device is fully charged, the battery light will be solid red.
Typical charging time is about 2-3 hours.
![mg-mini-lite-charge-device](https://staging.medicalguardian.com/wp-content/uploads/2023/10/mg-mini-lite-charge-device.jpg)
Important Charging Best Practices
- The MGMini Lite should be charged daily and can take up to 2-3 hours to reach a full charge.
- The battery will last up to 36 hours on a full charge. Battery life can vary depending on cellular strength, usage and fall detection events.
- If the device is removed from the cradle without sufficient battery, the device will state, “Battery low, please charge.”
- If the battery is low, the device will state. “Battery low, please charge” or “Call failed, battery low” when you press the help button. It will then power off.
- Please make sure the electric outlet you use is in a convenient location for you to access and is not controlled by a light switch to ensure consistent charging. To ensure adequate power avoid power strips and extension cords.
- Once in use, if the battery is low, the red battery light will slowly flash.Always wear your device.
- Failure to follow charging procedures will cause the device to not function properly.
- Always wear your device.
Initial Set Up
1-Plug the charging cradle into an outlet and wait for the red light to turn on.
![mg-lite-initial-set-up](https://staging.medicalguardian.com/wp-content/uploads/2023/10/mg-lite-initial-set-up.jpg)
2-Line up the gold pins on the charging cradle with the gold plates on the device.
![mgmini-lite-powering-off-new](https://staging.medicalguardian.com/wp-content/uploads/2023/11/mgmini-lite-powering-off-new.png)
3-Place the device into the cradle and wait for the device to say “charging”. The red battery light flashes every 5 seconds while charging. Typical charging time is about 2-3 hours.
![mgmini-lite-body](https://staging.medicalguardian.com/wp-content/uploads/2023/10/mgmini-lite-body-1.jpg)