HomeMini GuardianMini Guardian – TestingMini Guardian – Testing The Mini Guardian uses an automated testing feature called AVA.    Important! If the AVA is not able to hear you or confirm a test or accidental button press, a live operator will respond and follow...

Home Mini GuardianMini Guardian – Fall DetectionMini Guardian – Fall Detection Fall Detection can provide peace of mind knowing that our monitoring center will receive a signal to send help without the push of a button for additional $10.00 monthly. Fall Detection...

Home Mobile Guardian MD5 – FAQsMobile Guardian MD5 – FAQsTo power on the Mobile Guardian MD5: Option 1: Press the On/Off button on the side of the mobile device for approximately 5 seconds. All the lights will turn on and the green LED light will start blinking. This...

Home Mobile Guardian MD5 – TestingMobile Guardian MD5 – TestingGrab any/all buttons that should be tested and be within range of the mobile device. Press the transmitter button or press and hold the emergency button on the mobile device until the device starts...

Home Mini GuardianMini Guardian – Attaching/Detaching Lanyard and Belt ClipMini Guardian – Attaching/Detaching Lanyard and Belt ClipReplacing the lanyard with the clip Remove the lanyard by twisting and pulling silver clip. Pull the lanyard and clip away from the MG...

Home Mobile Guardian MD5 – Best PracticesMobile Guardian MD5 – Best PracticesThe mobile device has an unlimited, nationwide range and is GPS-enabled within the US where there is sufficient AT&T 4G coverage. Remember to take the mobile device with you when you leave...

Home Mobile Guardian MD5 – Fall DetectionMobile Guardian MD5 – Fall DetectionFall Detection can provide peace of mind knowing that our monitoring center will receive a signal to send help without the push of a button for additional $10.00 monthly. Fall Detection...

Home Mobile Guardian MD5 – Pairing a ButtonMobile Guardian MD5 – Pairing a ButtonGather any/all buttons that need to be paired, the mobile device, and the charging cradle. The charging cradle will need to be plugged into power. Power down the Mobile Guardian. Turn the...

Home Mobile Guardian MD5 – Parts Identification and Light IndicatorsMobile Guardian MD5 – Parts Identification and Light IndicatorsThe Mobile Guardian MD5 has one LED indicator around the emergency help button. Solid Red – charging Solid Green- fully charged No Light...

Home Mobile Guardian MD5 -Initial Setup and InstallationMobile Guardian MD5 -Initial Setup and InstallationFollow these steps to install the Mobile Guardian MD5: Plug the charging cradle into a power outlet not controlled by a light switch. Place the mobile device in...